Channel Radius Float 1850 x 150mm c/w Knucklehead & 3 x Snap Handles

Description

Channel Radius Float 1850 x 150mm c/w Knucklehead & 3 x Snap Handles is a complete rigid float kit for the first pass after screeding. A traditional bull float flexes across a wide slab, and passing over fresh concrete too late or with a tool that isn’t rigid enough leaves the flatness and tolerance short of what the job needs. This channel radius float is far more rigid than a traditional bull float, built to pass over the concrete immediately after screeding so flatness and tolerance are locked in from the start. It has a rounded end for floating and a sharp back edge for cutting, and comes complete with a Knucklehead worm-drive pitch control outrigger set and three 1.8m extension snap-handle sections. At 1850mm x 150mm, concrete finishers reach for this kit wherever a rigid, controllable float is needed straight after screeding on slabs and floors.